The integral PROFINET interface permits communication with:
The following protocols are supported:
The following can be connected:
Connection between PG and CPU of SIMATIC S7-1200
Connection between Basic Panel and CPU of SIMATIC S7-1200
Connection of several devices via CSM 1277 Ethernet switch
Point-to-point interface, freely-programmable interface mode
Communication modules permit communication via point-to-point connections. The RS 232 and RS 485 physical transmission media are used. Data transmission is carried out in the “Freeport” mode of the CPU. A user-specific, bit-oriented communication protocol is used (e.g. ASCII protocol, USS, or Modbus).
Any terminal equipment with a serial interface can be connected, e.g. drives, printers, bar code readers, modems, etc.
Point-to-point connection via CM 1241 in programmable interface mode
Power cable pre-assembled type: 6FX8002 C Connector full thread Sz. 1 for SINAMICS S120 Motor…
Custom-Made Pre-assembled cables for SINAMICS V90 Custom-Made Pre-assembled cables for SINAMICS V90 Custom-Made Pre-assembled cables…
Each DDM Diameter controller need to be aging tested before shipping out, make sure every…
If you are looking for a transformer for your application but cannot find it in…
Another project of the DDM-3020 diameter measurer has been done, take a look at the…
This website uses cookies.